• Used for nailing insulation, wind barrier boards, and other lightweight boards.

• Diameter 55 mm

• Material gray polyethylene (PE)

• Installed vertically at intervals of about 1 m

• Packaging sizes: 100 pcs/bag and 500 pcs/sack

• See additional information for the full selection of fasteners and more detailed product-specific information.

• Used for tying insulation in facade masonry.

• Attached against the frame structure with a steel tie.

• Diameter 64 mm

• Material gray polyethylene (PE)

• Packaging sizes: 100 pcs/bag and 250 pcs/sack

• See additional information for the full selection of fasteners and more detailed product-specific information.

• Used to transfer tensile stress and wind load on the wall directly to the frame structure.

• Can be nailed into place in advance and turned to the correct position as the work progresses.

• The minimum number of brick ties is 4 pcs/m², unless otherwise stated in the plans (RakMK-B8).

• Material black polyamide (PA)

• Does not include a nail.

• Packaging sizes: 100 pcs/bag and 250 pcs/sack.

• See additional information for the full selection of fasteners and more detailed product-specific information.

• Prevents insulation from sagging during framing, e.g., in a board-clad exterior wall structure between the frame and the outer cladding.

• The structure created with spacers improves the wall's thermal insulation. A simpler structure also saves timber.

• Suitable for both new construction and additional insulation of old walls.

• Nailing spacers are available for insulation thicknesses of 30, 45, 50, 60, and 70 mm.

• Material gray polyethylene (PE).

• Packaging sizes: 150-350 pcs/box

• See additional information for the full selection of fasteners and more detailed product-specific information.

•  

  Used for fastening insulation to concrete, block, or brick substrates.

• For example, for fastening vertical insulation on the inner side of a plinth.

• Drill with a ø 5 - 6 mm bit through the insulation to the fastening substrate and recess 25 - 35 mm depending on the insulation thickness.

• The size of the fastener is chosen according to the insulation thickness.

• Lightweight fasteners are available for insulation thicknesses of 50, 70/75, and 100 mm.

• Material gray polyethylene (PE)

• Packaging sizes: 100 pcs/bag and 300-400 pcs/box

• See additional information for the full selection of fasteners and more detailed product-specific information.

• For durable pipe fastening
• Suitable for use on various surfaces
• For pipes up to 16 mm
• Material red polyethylene (PE)
• Packaging sizes: 100 pcs/bag and 500 pcs/sack
• See additional information for the full selection of fasteners and more detailed product-specific information.

• Used between the CLT frame battens to keep the exterior cladding straight.

• Length 180 mm

• Material polyethylene (PE)

• Packaging size: 300 pcs/sack

• Does not include a screw.

• The required screw length = batten thickness + 180 mm + screw embedment into the CLT frame, minimum 48 mm.

• See additional information for the full selection of fasteners and more detailed product-specific information.

• Used for locking insulation boards side-by-side.

• A Finnish innovation.

• Manufactured in Finland.

• Material: galvanized steel

• Packaging sizes: 5, 40, and 240 pcs/box

• See additional information for the full selection of fasteners and more detailed product-specific information.

• Also available to order directly from our online store.

Feel free to ask our salespeople  for more information about the fasteners.